Results 1 to 10 of 17
Thread: Print starts above bed
Threaded View
-
05-01-2018, 06:16 AM #14
I’m not sure just what you mean about increasing the Z-axes maximum travel? The problem was that the limit stopped the Z axes travel short of the bed and did not allow the print head to reach it. Moving the limit switch down allowed more travel so now the head can reach the bed. If there is some setting in the firmware for that It would have no effect once the Z travel hits the switch.
I’ve been going through a steep learning curve for several weeks trying to get up to speed on this technology. You are only the second person to have responded to any question I have posted. The latest challenge is/was bed leveling, which turned out to be my most serious issue. I just yesterday made a modification to the unit to allow easier leveling. It’s posted elsewhere in the forum. Thanks for the response, Joe.
George
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion