Results 1 to 10 of 15
Threaded View
-
04-24-2018, 12:47 PM #9
Actually it's not.
We used to have an injection moulding expert, not been around for a while.
His advice was to print pet-g at a lower temperature for better layer adhesion.
have to admit I've never gone as low as 217. But I'll try it :-)
Currently playing with Tiamats ULTRA. World's first filament with nano-diamonds.
They only sent out 40 pre-sale sample reels and I've got one :-)
Currently printing bottle clips, as they're small, got some bridging and don't take long to make.
Currently on speed tests.
Up to 200mm/s max speed. Also upped all the other speed settings.
Supposed to be super strong, easy to print and great for printing at speed.
Looking good so far :-)
Printed Model of Motor Cooling Fan...
Yesterday, 02:07 PM in General 3D Printing Discussion