Results 1 to 10 of 474
Threaded View
-
02-22-2018, 06:21 AM #11
well I'm over halfway through the i3 parts and no issue so far.
Belts are tight. Also bear in mind I have two belt tensioners on each belt - so all three are at the exact same tension.
Even if the belts did stretch, the tensioners would take up any slack and you would have a visual indication as the arms on the tensioners closed.Last edited by curious aardvark; 02-22-2018 at 08:43 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help