Results 1 to 2 of 2
-
04-06-2014, 07:26 AM #1
How to Calibrate a 3D Printer Extruder
Found this video today on how to calibrate your 3D printer's extruder. I found it very informative. Has anyone ever done this, the same way as this guy?
-
04-06-2014, 10:39 AM #2
For anyone new to 3d printing this is a very beneficial guide and easy to understand. Don't ignore how important this step is. Just do it and you'll be happy you did. It will make your first printing experiences much more pleasant. I think most new printers are pre-calibrated and even kits like the Makerfarm i3 are really, really close right out of the but, but anytime you can eliminate a culprit and know definitively that something is NOT the cause of an issue, then life is better. It's better to know your extruder is behaving instead of just assuming.
I did the same calibration steps using another guide but felt like I needed PHD to even understand it. I did wind up with great calibration but this guide makes it nice and simple.Bambu P1S/AMS
NVision4D http://nvision4d.com
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion