Results 1 to 10 of 22
Threaded View
-
01-20-2018, 03:09 PM #16
- Join Date
- Aug 2017
- Posts
- 18
I don't seem to have a part like that. If it can be seen in my latest image, can you point out which one it is?
I printed at 240 degrees at 50% speed now for a few hours, it went ok. Until the filament didn't extrude any more and tangled up inside the print head. Had to drag out 50 cm filament from it afterwards. This is the second time that happens...
Then afterwards I manually push through some filament and it comes out perfectly. Such a mystery.................Last edited by veclock; 01-20-2018 at 03:34 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion