Results 1 to 10 of 22
Threaded View
-
01-18-2018, 06:23 AM #8
I was using different Slicers, Getting to know them and somehow it placed a 3.00 filament size into the printers defaults. Every time I rebooted it thought filament was 3.00mm.
Resting to firmware defaults restores the firmware's settings.
Do not know if this is your problem, was just putting out information I had experienced..Last edited by Roberts_Clif; 01-18-2018 at 04:52 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help