Results 1 to 2 of 2
Threaded View
-
12-22-2017, 06:40 PM #2
can not speak for FLSun Github Firmware.
However I have Marlin 1.1.x Running. I can see the settings you need for the FLSun I will help you get it running.
https://www.youtube.com/watch?v=Ok7igmasvXQ
I watched these instructions videos And believe I can Help I use Google Translate so if you cannot explain in English Write in your own language and I can translate to English.
Are you End Stops NC or NO (Normally Open or Normally Closed) By what you are saying they maybe setup wrong.
What is you Proximity sensor.Last edited by Roberts_Clif; 12-22-2017 at 06:59 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help