Results 1 to 10 of 10
Thread: Printing off-center
Threaded View
-
12-01-2017, 06:16 AM #10
one thing to check is that your printing start point is not set to: 0:0 as that is the top right corner.
For the bed size on the creators it should be: 110:75 (or the other way round). Basically you divide the width and length of the bed by 2 for your X & Y start point and that's your centre point.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help