Results 1 to 10 of 10
Threaded View
-
04-03-2014, 08:25 PM #8
- Join Date
- Mar 2014
- Posts
- 3
There are 11 printed parts total including the two halves of the mouthpiece. All told the final pieces took about 12 hours to print. I was able to do the bell and most of the longer sections in one shot. The slide inner tube mounts for the main slide and the tuning slide took 2 and 3 attempts each respectivly. The humb support bracket piece took two tries to get right. The back slide round popped off the bed on the first 4 attempts, so I ended up adding the removable print raft to it. Once I started doing that they printed really well. Assembly took about an hour, not including glue set time.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion