Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 10-20-2017, 07:07 AM #1
    raylo32
    raylo32 is offline
    Technician
    Join Date
    Aug 2017
    Posts
    95

    Another X One problem

    Not to beat up on Qidi because I love the printer and run it every day, but I have had another issue. Grinding stuttering in the X-axis. Curious that if I reboot the machine it will quietly go through its startup routine, testing the limits and homing, until the printhead reaches the front of the y-axis (no limit switch in that direction) then the grinding starts. Once that starts it doesn't matter where the printhead is, it keeps grinding and stuttering. Reboot and repeat. I am thinking perhaps the x-axis stepper cable is bad so I ordered up 4 from Amazon yesterday, coming today. I guess we'll see...
    Reply With Quote Reply With Quote
  2. 10-20-2017, 07:58 AM #2
    raylo32
    raylo32 is offline
    Technician
    Join Date
    Aug 2017
    Posts
    95
    Well, I just pulled the x-axis stepper motor cable and it tests OK. I am going to reassemble the printer and see if the issue persists and if so post up a video here and to Qidi support.
    Reply With Quote Reply With Quote
  3. 10-20-2017, 10:04 AM #3
    mjf55
    mjf55 is offline
    Technologist
    Join Date
    Jul 2017
    Posts
    193
    You should merge your two threads. I just responded in the other, but you have completed that here.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules