Results 1 to 10 of 15
Threaded View
-
10-15-2017, 02:18 PM #7
When you need more help Just POST. Have questions POST.
My first supply died, I jumped RT1 it was bad and replaced the Fuse. Only because I believe that having both was redundant, going on 1 year without RT1.
I also soldered wires onto a standard 7A fuse. But care must be taken not to heat the fuse too much or it can die.
Sand the ends of the fuse lightly tin the ends of the fuse tack a bare wire on both sides test too see if still good, solder into circuit.Last edited by Roberts_Clif; 10-15-2017 at 03:28 PM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)