Results 1 to 10 of 14
Threaded View
-
10-15-2017, 10:41 AM #5
Presently I am Printing the STL you supplied of course I was not intending to print the whole model just the bottom layers.
I do not see a problem. This model prints fine and appears to be strong enough
I can see the the model is 1 tube and 8 Ears in separated, thou when I slice using Cura 15.04.6 It appears the model slices as a solid one piece model.
Meshmixer shows the model has 8 errors, 1 for each of the Ears to be repaired.
Would ask what slicer you are using and the what settings you are using to slice this model.
I took the two crescent wrenches and could not break the Ears off with a moderately strong force. It did however brake with a strong force in about the middle of the Ear.
Test.jpgLast edited by Roberts_Clif; 10-15-2017 at 10:50 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help