Results 1 to 10 of 12
Threaded View
-
10-15-2017, 10:06 AM #8
- Join Date
- Oct 2017
- Posts
- 25
You're right mate. Thanks for not banning me. That was a 6 beer post.
I just got a bit torqued when I started watching the Youtube videos about Peachy and by Peachy. LOL. Ouch. And then I took it out on you and the forum. Not your fault, you've been quite hospitable. I have a strange sense of humor, that comes out wrong sometimes. There's no need to take me or anything I say too seriously.
A projector is a simple way to go about this, but I'll definitely look into your suggestion. A larger print area with good resolution are the reasons I want to look into alternatives.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion