Results 1 to 9 of 9
Threaded View
-
10-02-2017, 11:56 AM #7
try getting rid of the kapton tape. and just apply painters / masking tape direct to printbed. We have never had an issue with masking tape peeling off. Kapton tape on its own will also work. For PLA we have the bed set at 60C which works very well. if the PLA is coming off I would check that your bed is level and aslo that your nozzle to bed height is a single sheet of paper's thickness.
When you first use the bed after you have added the tape, heat it up and then smooth it down.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion