OK, I see the Replicator 1 Dual and that works. It still puts the lead out bead in the wrong place into the print zone (??) but at least has the table size equal to my machine. I was able to move the lead out bead by modifying the startup gcode by increasing the y axis location. I also tried specifying a print area beyond the OEM table size in the gcode to print past the table edge onto the glass that extends about 15mm on each side... and it didn't work. Print still stopped at the y-xis position of the OEM table edge. Hmmm... Need to try that some more. Only reason I care is I have one piece I'd like to print that is just a tad over and it won't work for its purpose if undersized.