Results 1 to 10 of 60
Thread: Choosing my first Delta Printer
Threaded View
-
09-24-2017, 05:22 AM #37
you're not going to get much better than that at 85mm/s
Good job :-)
Try it wothout the brim. You'll most likely need to slow the first layer down a bit (10% at 85 should work).
Unless the print has a really tiny base, you should never need to use a raft or brim.
Can't see any issues at all.
That ezbed setup looks pretty good.
So you buy the software and just make a z-stop sensor. Well I've already got one of those :-)
That software setup is exactly what all deltas should ship with !Last edited by curious aardvark; 09-24-2017 at 05:32 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion