Results 1 to 10 of 474
Threaded View
-
09-22-2017, 02:39 AM #11
- Join Date
- Jul 2017
- Posts
- 193
Leveled the bed to the horizontal extrusions.
Ran the G29 calibration. here is the result
03:39:52.432 : Info:Autoleveling disabled
03:39:54.271 : Z-probe:50.76 X:-66.00 Y:-38.00
03:39:57.698 : Z-probe:50.39 X:66.00 Y:-38.00
03:40:00.877 : Z-probe:49.50 X:0.00 Y:66.00
03:40:01.832 : Z-probe average height:50.22
03:40:01.835 : Info:Autoleveling enabled
03:40:01.837 : X:0.47 Y:65.95 Z:50.165 E:0.0000
Please explain what you are doing with this info
Played some more, and this is where I am at.
04:43:04.498 : Info:Autoleveling disabled
04:43:06.296 : Z-probe:47.74 X:-66.00 Y:-38.00
04:43:09.161 : Z-probe:47.78 X:66.00 Y:-38.00
04:43:11.908 : Z-probe:47.76 X:0.00 Y:66.00
04:43:12.690 : Z-probe average height:47.76
04:43:12.692 : Info:Autoleveling enabled
04:43:12.695 : X:0.47 Y:65.95 Z:50.165 E:0.0000
So, I think I got it. The data show ( I think ) that the bed is level (47.74 - 47.78 , just .04 low to high ). So I put double paper on the bed, baby z-stepped ( What about Bob ) down to where the paper just drags a little, then using the control panel, set z=0 ans saved to eeprom. That appear to to be it. I did not do the auto bed calibration, as that
Anyone disagree, please let me know. Also, I see people mention 'the math' and i dont know what that means. If anyone knows, please let let me know.
When using Repetier-Host, if the printer is at home, and I press the home button again, I get a pop-up saying "00 Your printer requested a pause. When I hit continue printing, I get a slow z movement down along with space music from 'Close Encounters Of The Third Time' until I reset the machine. Whats up with that?Last edited by mjf55; 09-22-2017 at 06:19 AM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion