Results 1 to 10 of 101
Thread: Network Printers
Threaded View
-
09-16-2017, 04:15 PM #11
In the picture with the green, black, and red boats the black boat on the right was printed at 0.025mm layer height with a 0.2mm nozzle. And at 40 layers per mm of build height the lines on the roof of the boat are all but gone. While everyone else is trying to chemically melt their prints to make the lines diminish. I know a better way.
Last edited by AutoWiz; 09-16-2017 at 04:34 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion