Results 1 to 10 of 60
Thread: Choosing my first Delta Printer
Threaded View
-
09-08-2017, 11:12 PM #29
- Join Date
- Jul 2017
- Posts
- 100
Oh you're talking about the G29 using 3 point. I set the points properly, but then it move to the first point, doesn't even probe it and just stops. Right now trying out UBL but it didn't work either. Here is the weird thing. Here is what the mesh said after the G29 UBL (Unified Bed Leveling):
17:13:10.568 : . . . 1.694 0.402 0.219 0.327 0.720 . . .
17:13:10.568 :
17:13:10.738 : . . 0.524 0.053 0.032 0.099 0.094 0.190 0.334 . .
17:13:10.738 :
17:13:10.909 : . 0.120 0.001 0.010 0.012 0.010 0.062 0.080 0.062 0.108 .
17:13:10.909 :
17:13:11.079 : . -0.003 -0.002 0.034 0.035 0.013 0.035 0.010 -0.036 -0.036 .
17:13:11.080 :
17:13:11.277 : 0.081 0.025 0.034 0.036 0.075 0.007 -0.015 -0.015 [-0.015] .
17:13:11.277 :
17:13:11.447 : . 0.140 0.109 0.061 0.082 0.095 0.059 0.035 0.058 -0.010 .
17:13:11.447 :
17:13:11.618 : . 0.179 0.119 0.075 0.077 0.061 0.073 0.086 0.067 -0.007 .
17:13:11.618 :
17:13:11.789 : . . 0.100 0.054 0.060 0.045 0.168 0.115 0.067 . .
17:13:11.789 :
17:13:11.959 : . . . . . -0.018 . . . . .
17:13:11.983 : (-114,-114)
Something is wrong on the top left of the bed, a whole 1mm difference?
I know I'm asking this again, but maybe I should print out those manual leveling knobs and try to level that way?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion