Results 1 to 10 of 11
Threaded View
-
08-20-2017, 05:04 PM #8
So you want to do
// M500 - stores parameters in EEPROM
// M501 - reads parameters from EEPROM (if you need reset them after you changed them temporarily).
// M502 - reverts to the default "factory settings". You still need to store them in EEPROM afterwards if you want to.
//define this to enable EEPROM support
#define EEPROM_SETTINGS
You will need to enable the Above line in you firmware
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help