I went to lowe's today and spent quite literally a few bucks on some threaded rods for the Y axis. Sadly they were too short. But also the Y carriage is meant to hold 3 short lm8uu bearings and I only have 2 short and 1 long lm8uu bearing on hand. So either I need to totally blow up the budget here or get creative with the printers. It's a tall order to not spend more money here. Aside from the z axis motor and top mounts I now need to design and print out Y axis ends that will extend the threaded rods and make adapters to space the bearings down below the plate a touch so I can mount the larger bearing and still have a level plate. During the week progress slows as I have to work and only have a few hours in the evening to do stuff.