What printer around 600€

[oxidized]

the qidi piddles on the xyz from a great height.

No clue whether the current ones use g-code or x3g files.
Flashprint works fine with them - basically an easier to use version of cura.

Checked their website - says g-code - so any slicer will work. :-)

basically it's a replicator dual pro. But upgraded and not using the mightyboard - so no need for x3g conversion :-)

Wow, well these 2 got my attention really, let me check what i can find here in europe, also the delta doesn't seem too complicated to build, easier than our old geetech at a first glance.

Download Flashprint and select Creator Pro as your printer. Find a small object for a first test print and see where the Davinci centers it. Have your finger on the reset/off button just in case it tries to jam the head into something. The Davinci does use an SD card, right?

No sd card, i have a davinci 1.0 Pro, probably older models support the sd card, i'll try using flashprint and do what you say, or better the printer is actually at my friend's atm, so i can only tell him what to do

Thanks guys your help is much much appreciated, anything else it comes on your mind, i'm here reading!