Results 1 to 7 of 7
Thread: New Qidi Tech 1 With Issues
Threaded View
-
06-04-2017, 10:49 AM #2
I'd say it's where the bed isn't level.
Looks like you're a little too close to the bed and it can't extrude fully. So you get backpressure build up and it comes out in spurts. Giving you really thin bits and splodgy bits.
Whenever I've had something similiar that's usually what causes it.
How did you calibrate the bed ?
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion