Results 1 to 10 of 19
Threaded View
-
05-15-2017, 04:46 PM #6
Ideally the firmware of your printer should be configured so that 100 is typical.
I print at 100 unless I'm doing 60mm/s prints (typically I do 35mm/s), in which I usually jack up my temps +10C and my flow to 110.
My last tip is: The consequences of under extruding are less detrimental than for over-extruding. However, at really low speeds (<15mm/s) you really do have to be concerned about heat soaking the filament and causing a nasty jam.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help