Results 1 to 10 of 19
Threaded View
-
05-15-2017, 03:49 PM #2
Considering the angle at which I expect this bracket to be under duress, I think printing it on its side (so that the layer boundaries are not perpendicular to the forces of stress) makes all the sense in the world.
I would reenable the retraction, or perhaps half the retraction, and print at a slower speed, making no other changes, and see how that comes out.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion