Results 1 to 10 of 50
Thread: The curse of ABS (Warping)
Threaded View
-
10-20-2013, 06:21 PM #13I actually do the opposite. I print with the first layer at 110C and the other layers at 80C within my "garbage chamber" (clear garbage bag chamber). I find that if I set the temp above 100C for the entire print I get some heat distortion of the part on the bottom layers.
Eric
Do you use kapton tape or do you print directly to the glass?
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion