Results 1 to 10 of 50
Thread: The curse of ABS (Warping)
Threaded View
-
10-20-2013, 06:21 PM #13I actually do the opposite. I print with the first layer at 110C and the other layers at 80C within my "garbage chamber" (clear garbage bag chamber). I find that if I set the temp above 100C for the entire print I get some heat distortion of the part on the bottom layers.
Eric
Do you use kapton tape or do you print directly to the glass?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help