Results 1 to 5 of 5
Threaded View
-
05-08-2017, 06:24 AM #2
yeah I tried pei tape for a short while - wasn't impressed.
I can recommend printbite. After 18 months of trying everything else I've been using printbite for over a year now, with no problems.
What printer do you have ? And what are the conditions of the room it's in ? temp and humidity primarily.
Enviromental conditions can have a disproportionate effect.
My biggest issue with blue tape is that it can pull off (although if you apply it to a hot bed, it's better) and you often get blue marks on the base of the prints.
Printbite isn't miraculous, but it's better by a long way than anything else I've tested in the last 3 years.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)