Results 1 to 10 of 23
Thread: Hot end Prusia i3
Threaded View
-
03-26-2014, 08:31 PM #23
Since you don't know what a bowden setup is, I'll assume you have the standard Prusa i3, which will uses the direct version of the E3D.
The only real difference is that the bowden version has a tapped end to accept the pneumatic fittings. I went with the bowden version just in case I want to upgrade later down the line.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion