Results 1 to 4 of 4
Thread: Powerspec i3 plus not printing?
-
03-31-2017, 04:57 PM #1
- Join Date
- Mar 2017
- Posts
- 3
Powerspec i3 plus not printing?
Hey,
I have a power spec i3 plus, (a re skinned wanhao i3 plus) and for the last few days it hasn't been printing. When I preheat the extruder and bed, then i go to the "print" screen. I select the file on the sd card that I am trying to print (I have tried many files), and right when it is about to reach printable temperature with the extruder and bed, the temperature on the right side of the forward slash, which it is supposed to reach, just turns into zeros, (ex. 110/0 C) and the percent completed bar begins to rise as if it were printing. (However the bar rises very fast.) I was hoping that someone with this printer that has experienced this issue or something similar could lend some help in what I have to do to get this fixed?
-
04-02-2017, 12:36 PM #2
Have you tried printing via usb cable ?
Sounds like it could be corrupted file or sd card.
-
04-02-2017, 05:00 PM #3
-
04-03-2017, 05:42 AM #4
next step is to reset the firmware to factory defaults.
If that doesn't work, start asking in the reprap section 'cos you'll probably have to take something to bits :-)
Design not printing solid
09-17-2024, 06:12 AM in 3D Modeling, Design, Scanners