Results 1 to 8 of 8
Thread: Strange problem with printing
-
03-30-2017, 06:05 PM #1
- Join Date
- Mar 2017
- Posts
- 3
Strange problem with printing
Hello!
I havn't been using my printer for a few weeks now and recently I bought a new filament (PET). It prints just fine, layers are perfectly constant without any gaps, hovever, the paths of filament are strangely thin, as a result i got strainer-like item. what should I do first and what is the problem?
-
03-31-2017, 06:03 AM #2
try printing at either a slower speed or a higher temperature.
Or both :-)
I'd go for too low printing temp.
Plus pet-g printed cool is actually weaker than pla and has layer seperation issues if you flex it.
Actually had a piece of pet-g flake off and hit me in the face. The same part in pla flexes better and doesn't shoot bits at me.
So next time I use the pet-g I will be upping the printing temp by at least 15c.
-
03-31-2017, 06:49 AM #3
- Join Date
- Mar 2017
- Posts
- 3
I'm not sure about higher temperature. I would use PET (not PET-g) some time ago and it was my preferable material because it was easy to print and quite flexible. I was printing it at 235-240c but now it was not enough. I turned it up to 250 but leter I decided to use 246c and it was ok I think. I'll try to reduce speed but I'm thinking about comparing it with second extruder and see what to do next.
-
04-01-2017, 04:07 AM #4
PET has a high surface friction. If you are using a Bowden tube it can be that the friction prevents extrusion so you will need a higher flow.
With PLA the same stringing can occur when the temperature is too high, then the filament forms droplets and comes out like a bead string.
-
04-02-2017, 05:07 AM #5
pet is very different to pet-g.
so can't really compare the two.
-
04-09-2017, 05:06 AM #6
- Join Date
- Mar 2017
- Posts
- 3
I think I found the problem. I have no idea why but the build plate goes down a little every time when heated. I just decided to level it just after canceling the print which went bad. Build plate was too low which was strange due to a fact that i've leveled it about two days ago. I believe it's fine now.
-
04-10-2017, 05:35 AM #7
yep. Hotter the buildplate the quicker it goes out of true.
yet another reason I stopped using abs :-)
-
05-18-2017, 07:36 AM #8
- Join Date
- May 2017
- Posts
- 1
With mesh patterns you can make so much nice things! For example, i have built dollhouse for my daughter. It turned out so beautifully, she even wrote about it in her blog - casestudywriter .
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery