Results 1 to 2 of 2
Thread: .8 nozzle troubleshooting
-
02-28-2017, 06:32 PM #1
- Join Date
- Feb 2017
- Posts
- 3
.8 nozzle troubleshooting
I have a monoprice maker select printer and I am using Cura as my splicer. I have been using a .4 nozzle and have had a lot of success with the printer, but I recently bought a mk10 .8 nozzle for an upgrade and now the printer will touch the bed, then begin the print and print 1 to 1.5 millimeters above the bed. I am not sure why a .8 nozzle would cause my slicer to have it print that high but is there a way to fix this issue?
-
02-28-2017, 06:36 PM #2
- Join Date
- Feb 2017
- Posts
- 3
Another question! I am barely printing at 1.5mms per second, is that speed too low for my printer?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion