Results 1 to 10 of 15
Thread: Severe Delamination Help
Threaded View
-
02-07-2017, 04:28 PM #13
Sigh............... I've never seen glass break apart... and raise up.......
My glass bed is filled with pot holes. I need to span those gaps. CA's advice seems to be a perfect solution.
You seem to assume that ALL printer's work like yours, that you can easily remove the glass and throw it into a freezer. Even if I had a freezer empty enough (A full household of kids kinda prevents this) to place my print into, the labor of completely disassembling the case of the printer, disassembling the Z axis, unplugging the bed from the board, placing that in a freezer, removing the print, reassembling the Z axis, plugging it back in, reassembling the case, is kind of a pain in the ass.
If you want to be helpful, make sure to read the OP's, and then respond constructively to that. CA offered a very viable, and CHEAP, solution to my problem. Not one of your comments was any help at all.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help