Results 1 to 10 of 29
Threaded View
-
02-05-2017, 11:39 AM #19
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
It is definitely an improvement. Your suggestions along with some input from Micro-Swiss has helped.
I agree on heat. I am now running the bed at 90 to start and dropping to 80 on this run to see how it goes. Also running the fan after a few layers.
Running at 2000mm/min. I think too slow on print speed on the layer and the nozzle has to much time at any one spot.
I haven't tried a thinner layer yet. I am thinking to remove the top to let some heat out. Overall warping is not really an issue not is adhesion.
Thanks for the suggestions.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help