So, I ordered some borosilicate glass from McMaster-Carr and it finally arrived. I've got a print for a 5mm Z-axis spacer printing now.
Any special cautions or tips on this stuff? Just use binder clips and AquaNet?
I use only Gino to attach it to the plate, no need for clips.
What thickness did you get? My original was 1/4" and a chunk pulled out of it when removing an ABS piece. Went to 1/8" and haven't had any issues so far.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion