Results 1 to 8 of 8
Threaded View
-
02-01-2017, 10:17 AM #5
I've only used netfabb a couple times with SU models, and those were under special circumstances. 99% of SU models should already be ready to print with the solid inspector plugin. This plugin tells you if your model is manifold or not, and highlights errors. This should allow you to skip any 3rd party software for model repair.
And it may be the TV viewer, but it appears your model is still not laying flat.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion