Results 1 to 5 of 5
Thread: heater pin numbers
Threaded View
-
01-28-2017, 02:29 PM #2
Not sure what you have for hardware or firmware, but I believe the typical Marlin/RAMPS config is as follows:
HEATER_BED_PIN 8
HEATER_1_PIN 9
HEATER_0_PIN 10
It can be tricky to work through the #if #else #endif logic. Always check to make sure no more than one definition is assigned to any pin for your specified motherboard type.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help