Results 1 to 10 of 29
Threaded View
-
01-28-2017, 11:04 AM #5
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
There are actually 8 gears printing and a block and 8 pins that fill the entire bed so there is quite a bit of time between layers!
I tried a run on the QIDI with the standard extruder setup and it was better but the edges of the gear teeth still look "chewed" on! I was getting curling at the points of the gear teeth so I turned on the fan. I think that slowed the curling some.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion