Results 1 to 10 of 10
Thread: Bad 3D Benchy
Threaded View
-
01-24-2017, 08:14 AM #3
As above, please post a link to your slicer setting and that will really help.
However, a few points:
It seems that your Benchy is fairly small and this may affect the quality of the model. (try printing bigger if possible)
Also, your layer height (resolution) seems quite high. I would suggest a layer height of 0.1mm. Or if you want a really detailed model perhaps try 0.05mm layer height.
I can also see your infill lines showing through. Although this is common and probably not something that is very bad, you can fix this by having a thicker wall (try 0.8mm) or asking your slicer to print the wall before the infill.
I hope some of these above points help. With a picture of your settings I might be able to be of more help.
Regards,
3DEX - Great Filament
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help