Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
01-21-2017, 08:29 PM #8
- Join Date
- Jan 2016
- Posts
- 81
I have a question for all the QIDI Guru's out there, (Yous guys)
I have found that I need to replace my extruder motors, and they are as follows:
42HB34F08AB rated at .8 amps.
I have found motors that meet most all needs except they are either 0.4, 1.2, or 1.5 amp rated....
Will this matter, or damage anything if I go up higher than .8 amps? Can the power supply handle it? Should I go with the lower 0.4?
Also, most of the ones found are a little longer at 40mm, versus the 34mm of the stock, will this effect anything??
Thanks in advance!!!
Also if anyone has a link to a replacement extruder motor that is pug and play let me know!!!
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion