Results 1 to 9 of 9
Threaded View
-
01-14-2017, 07:25 AM #9
- Join Date
- Jan 2017
- Posts
- 6
Got it!
My wife corrected my color blindness and i flipped the X and Extruder motor rotations by flipping one phase of the motor. On the MM's per inch I can adjust the extruder from the LCD panel, unfortunately I have to do this each time I power up else I have to go down the route of re engineering the firmware which I may do in the future.
The E3D hot end and Titan extruder are a quantum leap better than the clone Mk 8 extruder that came with my cheap printer.
Thanks for the suggestions, I'm back to printing stuff.
Jeff
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion