Results 1 to 8 of 8
Threaded View
-
01-11-2017, 10:25 AM #5
- Join Date
- Nov 2016
- Location
- Lancashire, UK
- Posts
- 36
Hi rudschul, On the advice of Sintratec, I have not yet tried experimenting with the parameters. However, on my OpenBeam Kossel Pro I have done a huge amount of experimentation and can print down to 0.2mm wall thickness. This is the kind of thicknesses I am after and if the Sintratec kit is capable of printing just outlines this would open up a huge area for experimentation. By using surface modelling instead of solid modelling I can persuade Simplify3D to print single outlines but it looks like the Sintratec software does not recognise anything below 0.5mm, in the default settings. I will experiment with the custom settings and report back.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help