Results 1 to 7 of 7
Threaded View
-
01-10-2017, 08:34 PM #3
- Join Date
- Dec 2016
- Posts
- 43
I'll check that when i get back to my printer.
looking at your picture I see your motor mounts and threaded rod are sturdier then what came with my kit. The clear rubber sleeves I have doubts about, today while printing a job the threaded rod on the opposite side slipped out of the sleeve and was about a half inch in the air before i noticed it. their isn't enough clearance to zip tie the sleeve to rod so i'm at a loss as to prevent this from happening again.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help