Results 11 to 12 of 12
-
01-03-2017, 11:36 PM #11
Yeah... I don't understand why they refuse to be standard and put the X Axis endstop on the left side and plug it into the X-Min pin. That makes no sense other than that is how they finally got the prototype printer going and refused to make any further changes.
When I was assembling my i3-2020 I saw what they were saying to do and said "Screw that!" I'm putting the limit switch on the left side and plugging it into X-Min!
But other than that.... I've got nothing but good to say about the kit. For the money, this is is a very good printer.
-
01-04-2017, 06:45 AM #12
- Join Date
- Jan 2017
- Posts
- 2
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion