Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
12-31-2016, 10:48 AM #10
- Join Date
- Dec 2016
- Posts
- 5
Hey everyone!
Before I start taking apart the extruder, I thought I'd ask a question I am sure is on the previous 381 pages! :-)
I have been doing fine with prints up until now. All of a sudden, I hear clicking which I assume is coming from the hobble gear skipping on the filament. The printer, while this was going on, was under-extruding. (I have seen this in the past with my other 3d printers during over-extrusion when it just can't push the filament out quickly enough.) I was able to extract the filament and run the extruder without filament. No clicking. When I put the filament back in and just try to extrude some into the air, I see it is under-extruding and clicking again.
Thoughts prior to a disassemble?
Thanks!
Update: I pulled the motor, heat sink, and fan off. They look fine. My guess is there is a clog further downstream.Last edited by ycoidi; 12-31-2016 at 11:00 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help