Results 3,811 to 3,820 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
12-28-2016, 07:16 PM #3811
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-29-2016, 07:47 PM #3812
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
Well, I throw in the towel on this. I have tried two scripts and neither works correctly. Then slic3r just make s a huge mess. It changes to the wrong temps after the first layer. It is massively under extruding etc. All of this is actually on my Flashforge Creator Pro. When I run it on the QIDI it is even worse.
I don't know what the issue is but I am far from getting anything to even come close to a real print.
-
12-29-2016, 10:59 PM #3813
- Join Date
- Apr 2016
- Posts
- 12
-
12-30-2016, 08:07 AM #3814
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-30-2016, 02:34 PM #3815
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Hey W, Here is a New Years present. I guess it's actually a re-gift cause I just found it on Thingiverse. No idea if it works or will crash your printer either, so I guess that makes it kind of a lame present...
http://www.thingiverse.com/thing:2005590
Happy New Year to all
-
12-30-2016, 02:40 PM #3816
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-30-2016, 08:34 PM #3817
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-30-2016, 11:11 PM #3818
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
I've looked at those on his website, but haven't purchased them yet. I think they seem a much more elegant arrangement than the stock one. Should make keeping things accessible, aligned and stable much easier. I am most curious to learn how the hot ends behave vice the stock parts. Can you safely reach the higher temps needed for some materials now?
-
12-31-2016, 07:26 AM #3819
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-31-2016, 10:48 AM #3820
- Join Date
- Dec 2016
- Posts
- 5
Hey everyone!
Before I start taking apart the extruder, I thought I'd ask a question I am sure is on the previous 381 pages! :-)
I have been doing fine with prints up until now. All of a sudden, I hear clicking which I assume is coming from the hobble gear skipping on the filament. The printer, while this was going on, was under-extruding. (I have seen this in the past with my other 3d printers during over-extrusion when it just can't push the filament out quickly enough.) I was able to extract the filament and run the extruder without filament. No clicking. When I put the filament back in and just try to extrude some into the air, I see it is under-extruding and clicking again.
Thoughts prior to a disassemble?
Thanks!
Update: I pulled the motor, heat sink, and fan off. They look fine. My guess is there is a clog further downstream.Last edited by ycoidi; 12-31-2016 at 11:00 AM.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery