Results 1 to 1 of 1
-
12-29-2016, 09:54 PM #1
- Join Date
- Dec 2016
- Location
- Idaho
- Posts
- 5
Hictop prusa i3 Z height issue after Firmware Flash due to Auto Level kit install
Hellllooooooo Printer Geeks !
I just installed the Auto Level Kit on my printer . Afterwards I used Cura to flash my 3DP08 to 3DP12 via the hex file provided to me by Hictop.
My printer is http://www.hic3dprinter.com/products...&id=25&cid=001
Now my Z axis height will no longer go all the way up and travels VERY slow . In the menu it shows it went up 200 but in actuality it only goes up about 3.5 inches max .
This is ruining prints and I need this fixed asap as I am now having a backlog of prints.
Can someone please help me?
PS, I'm a moron when it comes to manual programming of any kind....hence using Cura to flash the hex update file and not using Arduino in any way like I see on other forums.
Cheers!
RIP Carrie Fisher
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion