Results 11 to 13 of 13
-
12-27-2016, 05:22 AM #11
- Join Date
- Mar 2016
- Location
- Düsseldorf
- Posts
- 9
-
12-27-2016, 05:29 AM #12
- Join Date
- Mar 2016
- Location
- Düsseldorf
- Posts
- 9
I increased the gap, but it still happens on some areas of the print.
lines2.jpglines1.jpg
I tried to take a picture. On some areas, some "strings" of the first layers lift from the raft just before the nozzle moves to the same spot. Than the nozzle hits the "strings" and burns them. But I can't see why this happens. The areas next to them are fine again…
Without raft I can't even print the first layer. I don't have a Buildtak, I use "ABS Juice".
ThanksLast edited by Scrapenbaker; 12-27-2016 at 05:34 AM.
-
12-28-2016, 11:43 AM #13
- Join Date
- Mar 2015
- Location
- Slovenia, Europe
- Posts
- 76
Did you try to reduce Model to raft distance?
By Default it is 0.23. Reduce it to 0.18 maybe.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery