Results 1 to 3 of 3
Thread: Can't open file from SD card
Threaded View
-
12-17-2016, 11:24 AM #2
- Join Date
- Jan 2016
- Posts
- 326
I think that I may have a bad SD card. I printed a cylinder head from the SD card and my printer froze about 3/4 of the way. What a terrible waste of PETG filament. This morning, I rotated the engine block halves 135 degrees so that that the cylinders are vertical and sent the file through USB port. I hope that the prints are successful.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion