Results 3,781 to 3,790 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
12-13-2016, 07:41 PM #3781
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-13-2016, 10:11 PM #3782
That looks awesome too! What filament did you happen to use for that print?
-
12-14-2016, 06:09 AM #3783
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
This is Hatchbox translucent green. It is lighter than I would like but prints really nice. I have printed these between 190 and 215 and seen no noticeable differences in color or print. Seems to be pretty stable. The translucent red is vivid and rich.
-
12-14-2016, 02:58 PM #3784
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
12-14-2016, 03:02 PM #3785
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 902
-
12-15-2016, 06:56 PM #3786
- Join Date
- Dec 2016
- Posts
- 5
Hello!
First time poster! I'm sorry if I missed this in 379 pages (I kinda skimmed them), but I just received my printer and am all ready to set it up. The included SD card is completely blank (no instructions, software, etc.).
Where can I track down an image of the SD card (or, at the very least, get the setup instructions)?
Thanks!Last edited by ycoidi; 12-15-2016 at 07:13 PM.
-
12-15-2016, 07:02 PM #3787
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Contact Emily at QiDi. Her email address is emily@qd3dprinter.com
-
12-15-2016, 07:06 PM #3788
-
12-15-2016, 08:06 PM #3789
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
12-15-2016, 08:14 PM #3790
- Join Date
- Dec 2016
- Posts
- 5
I contacted her and got all the files. That was quick! Thanks for the help!
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery